Me372_ang

markets and enables provision of an AMRand prepayment service. It is a single- phase meter intended for use in residential applications. The meter incorporates afully integrated GSM/GPRS modem that can be exchanged with integrated RS485communication interface for block installa-tions. It is a perfect combination of well-proven metering technology and state-of-the-art GSM/GPRS modem, all integratedand sealed in a single enclosure. The inte-grated solution attains the same high qual-ity and reliability of Iskraemeco meters.
The meter is approved according toIEC 62052-11, IEC 62053-21, ISO 9001,and designed according to even higherinternal Iskraemeco standards, based on60 years of experience of meter manufac-turing and more than 55 million metersinstalled worldwide.
Real-time clocksynchronised by comm.
■ Fully Integrated AMR communication – GSM/GPRS/SMS ■ 'Fit and go' – simple and fast installation procedure■ Multi-utility input for gas or water meters ■ Power disconnection or limitation – integrated switching device ■ DSM: local or remote load control – integrated load relay■ Indication of operational status Active and reactive energy in both energy flow directions Built-in LEDs indicate active and reactive energy flow.
– import (A+), export (A-) and absolute IAI, accuracy Blinking frequency is related to energy consumption. Maximum demand with programmable integration period (typically 5, 10, 15, 30 or 60 minutes) Power quality parameters
• Super Cap for backup power supply (up to 10 days) • Data can be displayed in automatic or manual scroll • Number of short power-downs (less than 3 min- • Data identification according to IEC 62056-61 Self-consumption voltage c. .<2 W / 10 VA Multirate registration
Switching device state, energy flow direction, self-diag- • Programmable tariff structure, up to 4 rates nosis parameters as well as some communication • 3-state GSM signal level indicator (high, low, too low) Load profile
• The meter detects the main cover and the terminal • Two independent load profiles (LP1, LP2) up to cover opening, records it in a logbook and optionally • Programmable LP period (typically 15, 30 or • Capacity (one measurement value with a time stamp Programming of the meter as well as Firmware upgrade One 6 A relay is integrated into the meter. It can be can be done locally (via an optical port) or remotely (via used for load control according to the internal tariff a GSM modem) in compliance with the predefined secu- Log book: up to 64 events with a time stamp
GSM/GPRS/SMS
High quality 100 A switching device (106 actions) is integrated into the meter. Information about the state • IP 54 protection against water and dust of the switching device is available in the certain regis- • Dual-band EGSM 900/1800 MHz is supported ter and on the display (code red and load limitation func- • High performance internal antenna is integrated into • MeterRead software for local reading and program- External antenna option
The meter is equipped with an M-Bus micro master to • MeterView software for local or remote programming Available for installation in case of insufficient GSM which up to 4 gas, heat or water meters can be con- signal. An external antenna can be connected via a special inductive coupler - no need to open a meter or The meter is optionally equipped with two additional SIM card exchange
inputs (an external alarm device can be connected).
OVERALL DIMENSIONS (mm)
A SIM card can be hot-swapped and automatically reg-istered in a GSM network. The SIM connector is designed for high reliability contact and is positioned The meter can perform a call and send a message to Optionally, instead of a GSM/GPRS modem, the meter • If a pre-defined alarm condition exists can be equipped with RS485 interface. Up to 31 meters can be connected to one communication • If a signal appears on the alarm input The meter can be remotely switched to the prepayment mode. Information about purchased energy amount is • IEC 62056-46 (DLMS) on a GSM modem and sent to the meter remotely. The purchased energy is consumed according to the tariff program.
• IEC 62056-46 (DLMS) and IEC 62056-21 (former • Universal clamping type: D=8.5 mm or D=9.5 mm Owing to periodical improvements of our products the supplied products may differ in somedetails from the data stated in the prospectus material.
Iskraemeco, Energy Measurement and Management4000 Kranj, Savska loka 4, SloveniaTelephone: (+386 4) 206 40 00, Telefax: (+386 4) 206 43 76, http://www.iskraemeco.si, e-mail: info@iskraemeco.si Published by Iskraemeco. Data subject to alteration without notice.

Source: http://nekon-energo1ed.1gb.ru/files/ME372_eng.pdf